Engraving machine operation and maintenance maintenance - engraving machine

Engraving machine operation and maintenance maintenance

1. Before starting the machine, first check whether the handle of each part is in the normal position, whether the moving parts are in good condition, and the guide rail is lubricated with oil, and then turn the bottom of the machine quickly for 1 to 2 minutes to observe whether there are abnormal conditions, and then the machine can work after the normal operation.

2. Spindle, workbench and guide rail surface are strictly prohibited from knocking and impact, workbench and track surface are not allowed to misplace tools and blanks and unrelated workpieces or articles.

3. Reasonable milling, adjust the appropriate magnification (reduction) multiple, according to the processing situation to select the tool, speed, feed, processing speed and direction of forward and reverse milling.

4, the entire processing process, do not wear gloves, for the processing of sawdust splash should be good eye protection work, the processing process can not use the hand or rags and other debris contact is rotating the tool, in cleaning the sawdust to ensure that the tool completely stop running in order to remove the sawdust.

5. After finishing the operation, turn off the power and remove the wood chips and debris. Other relevant AIDS must be returned to their place.

6. Work table and guide rail are wiped clean every day, no wood chips, oil impurities, etc.

7. Continuous operation time of less than 10 hours a day, to ensure the cleaning of the cooling water and the normal work of the pump, must not make the water-cooled spindle motor appear water shortage phenomenon, regular replacement of the cooling water to prevent the water temperature is too high. The cooling water in the water tank must be replaced once a day; 8. After each use of the machine, pay attention to cleaning, be sure to clean the dust on the platform and transmission system, and lubricate the transmission system (X,Y,Z three axes) regularly (every week). Guide rail can use oil gun oil, screw need to add 0# grease or butter;

9. If the machine is not used for a long time, it should be refueled regularly (weekly) to ensure the flexibility of the transmission system.

10. Regularly (according to the use) clean the dust in the electrical box and check whether the wiring terminal screws are loose to ensure the safety and reliable use of the machine circuit;

11. Check the screws of each part of the machine regularly (according to the use) to ensure the reliable operation of the machine.

12. When performing maintenance checks on electrical appliances, be sure to cut off the power supply until the monitor has no display and the main circuit power indicator light is off.

13. When the power is off, the position of X.Y.Z. axis cannot be forcibly moved manually;